Power is often wanted in sheds and garages, but it can be awkward and expensive to run long cables from the nearest power point. Solar panels, or in some cases small wind turbines, can be the ideal solution. It might be a single small solar panel used to power occasional low energy lighting, or a bigger installation giving enough power to drive an inverter producing mains voltage for power tools and other appliances.
For applications such as a garden shed or garage, framed solar modules tend to be the most appropriate power solution - the flexible modules we sell are better suited to expedition use (because they are light) or for use on boats where they can bend to a surface of a roof and have a low profile. Framed modules are generally cheaper for a given power output than flexible ones, and are more easily mounted unless you have a flat space to glue the thin, flexible panels down. They tend to be very robust and you can expect a very long working life with very little maintenance
There are however two types of framed panel to choose from - crystalline or amorphous. Either will work fine in this application, and to be honest there is little to choose between them. Amorphous (or 'thin-film') panels are bigger for a given power output than crystalline panels, so if you only have a limited space go for crystalline panels such as the BP Solar models. There is little difference in price - but one advantage of the amorphous panels is that they are more efficient at low light levels than crystalline panels, which is an important advantage in the depths of a British winter. UniSolar are the biggest manufacturer of amorphous panels.
You should try and mount the panels facing south, at quite a steep angle - about 60 degrees is best for the UK. Don't worry if your shed has a roof that doesn't face directly south though, or has a shallower pitch - you will get slightly less power from the panels but the difference isn't enormous. One 50-60 Watt panel attached to a couple of 100Ah lead acid batteries through a SunGuard or SunSaver controller should give enough electricity to power lights for a couple of hours a night for most of the year. If possible, use low voltage fluorescent or LED lights - they are more efficient. If you only need lights occasionally, or for short periods, you can get away with smaller panels - our smallest panel, the Spectra 5W panel will be quite adequate for occasional lighting use.
Running power tools off an inverter is also very practical - because they are typically only used for a few minutes or so at a time, the amount taken out the battery isn't as much as you might expect. But if you want to run a fridge to keep your beer cold you might need several panels, and even then don't expect to be able to run it in winter - fridges are notoriously power hungry, and because they are on all the time they consume a lot of power!
Wind turbines can also be a useful source of power, especially in winter when there is less solar power available. However, they do require a clear airflow, with few obstructions upwind of the installation in the prevailing wind direction. Unfortunately for that reason they often perform poorly in urban areas. On the other hand they can be an ideal solution for remote barns for example, especially when they can be mounted at a high level where the wind is stronger. The Rutland range of small wind turbines are ideal for this sort of installation.
High quality framed crystalline solar panels from BP Solar
BP Solar panels
Good value framed amorphous solar panels from UniSolar
UniSolar framed solar panels
Wide range of solar regulators from MorningStar
MorningStar regulators
Rutland wind turbines: quiet and efficient
Rutland Turbines
Efficient low voltage fluorescent lighting from Labcraft
Labcraft lights
Semi-flexible thin solar panels
Spectra solar panels
Flexible adhesive backed solar panels from UniSolar - the ultimate low-profile, hassle-free solution
Unisolar laminate solar panels